The Lancia Beta (Type 828), stylised Lancia β, was an entry-level luxury car produced by Italian car manufacturer Lancia from 1972 to 1984. It was the first new model introduced by Lancia after it had been taken over by Fiat in 1969.
The Beta was made in several body styles, namely 4-door fastback saloon (Beta berlina), 4-door three-box, notchback saloon (Beta Trevi), 2-door coupé (Beta Coupé), 2-door targa (Beta Spider), 3-door estate (Beta HPE); a mid-engined sports car was also sold under the Beta name, the Lancia Beta Montecarlo.
Etymology The company chose the name Beta for a new vehicle to be launched in 1972, symbolising a new beginning as it reflected the fact that the company's founder, Vincenzo Lancia (1881–1937), had used letters of the Greek alphabet for his early vehicles – Alpha, Beta, Gamma, Delta, and so on. "Beta" had been used before, first for Lancia's 1908 car and again for a 1953 bus. Lancia had previously used the first letter of the Greek alphabet, Alpha, but this was not chosen for the new 1972 Lancia due to the obvious confusion it might cause with Alfa Romeo models.
Origins
When Fiat acquired Lancia in 1969, the company had been without a Technical Director for the year following the death of Technical Director Antonio Fessia. Ing. Sergio Camuffo was given the job of developing the new model in early 1970.
Although in the difficult years before the Fiat take-over, a number of the engineering staff had left the company, Camuffo was able to pull together a core of Lancia engineers, who were tasked with getting the car into production by the end of 1972. Romanini, chassis design, Zaccone Mina, engine development, with Gilio and Bencini in testing. This was a very short timeframe, and development money was relatively limited. These were key factors that influenced the decision to use an existing power plant: the Fiat twin overhead cam, straight-four engine with its alloy head and cast iron block."Lancia Beta - A Collector's Guide"
At the Beta's launch late in 1972 Fiat chief Gianni Agnelli told journalists that Lancia's output would be about 40,000 units in 1972 at a time when a volume of 100,000 was needed to cover the fixed costs involved in developing and building the cars. Lancia's lack of profitability was also evidenced by the absence of replacement models under development at the time of the Fiat take-over. The Lancia Fulvia, though much loved, had been developed with little concern for making it cost-effective to manufacture; it had therefore been sold at a high price in correspondingly low volumes.
The company's new owner's objective with the new Beta was to retain the quality image and price premium of existing Lancias, while minimising development time and production costs, using in-house Fiat group technology and parts where possible. The project adapted a well-regarded existing Fiat engine, fitted transversely and driving the front wheels, in line with Fiat's investment in this configuration during the previous decade. The gear box was a development of a transmission unit then being developed by Fiat-partner Citroën for a forthcoming model of their own. Above all, and in contrast with the Fulvia, the Beta design was relatively inexpensive to produce in volumes significantly higher than those achieved by predecessor Lancia saloons.
Features All versions of the car came with DOHC engines, five-speed gearboxes, rack and pinion steering, fully independent suspension using MacPherson struts, both front and rear, with disc brakes on all four wheels. The front-wheel-drive models were available in a number of engine capacities ranging from 1.3-litres to 2.0-litres. Breathing was provided by a single Weber carburettor until fuel injection was introduced on late two-litre HPE and Coupe models.Brian Long, Lancia Beta, A Collector's Guide (1991)
As with a number of previous front-wheel drive-Lancia models, the engine and gearbox were mounted on a subframe that bolted to the underside of the body. However, in the Beta the engine and manual gearbox were fitted transversely in-line. This Fiat-inspired configuration not only enabled neat engine bay packaging, but also, by tilting the engine 20 degrees rearwards, the Lancia engineers achieved improved weight transfer over the driven wheels and towards the centre of the car, as well as lowering the centre of gravity. The rear-wheel drive Lancia Montecarlo employed a similar layout except the subframe was mounted at the rear.
On the front-wheel drive Betas, Lancia designed a particularly original independent rear suspension with MacPherson struts attached to parallel transverse links that pivoted on a centrally mounted cross member bolted to the underside of the floorpan. An anti-roll bar was fitted to the floorpan ahead of the rear struts with both ends of the bar trailing back to bolt to the rear struts on each side. This unique design went on to be used in later Lancia models. The design was never patented by Lancia, and consequently inspired similar rear suspension system layouts in other manufacturers' vehicles during the 1980s and 1990s.
A short wheelbase coupé was introduced in June 1973, then the following year the 2+2 Spider convertible. At the 1975 Geneva Motor Show Lancia launched the HPE (High Performance Estate), styled in a similar vein to the Reliant Scimitar and Volvo 1800ES while utilizing the wheelbase of the Berlina. Later the Beta Montecarlo, a two-seater mid-engined coupé was launched.
The different models all underwent various revisions and improvements over the years. Power steering specially produced by the German company ZF became available on certain Left Hand Drive models and was also used on the Gamma. For 1975 the exterior styling was modified by Pininfarina: "the back window has been relocated in a more upright position" to aid visibility, the rear quarter pillars gained sharper trailing edges, the waistline was lowered and windows made larger.Autocar, 22 November 1975, page 23. Electronic ignition became available in 1978. Automatic transmission became available the same year; the Beta was the first Lancia manufactured with an automatic transmission factory option. In 1981 power steering also became available on certain Right Hand Drive models. Also in that year a fuel-injected version of the 2.0-litre engine became available on certain models. The Coupé and HPE underwent a facelift in June 1983 (at the same time that the supercharged VX versions were introduced) and remained available for a little while longer than the other bodystyles.
Late in the model's life Lancia released the Trevi VX, with a Roots-type supercharger fitted between the carburettor and low-compression two-litre engine; the Coupé VX and HPE VX followed soon after (June 1983). These three variants were known as Volumex models and had the highest performance of all the road-going production Betas, with and substantially increased torque over the normal two-litre . The Coupé VX and HPE VX can be distinguished from the normal cars by the offset bulge on the hood which is required to clear the new air intake, a spoiler fitted below the front bumper and the rubber rear spoiler. They also have stiffer spring rates. Lancia produced 1272 Coupé VX, 2370 HPE VX and 3900 Trevi VX. Most were left-hand drive (only 186 right-hand drive HPEs and around 150 RHD Coupés were imported to the UK, however the car was also sold in some other RHD markets so exact RHD production remains unknown). Only one right-hand drive Trevi VX was made.
A small number of Trevis were built to run on LPG rather than petrol (gasoline).
In North America This car marked a brief return of Lancia to the United States market beginning in 1975. Federalization was not quite harmonious, though, which combined with a lack of dealers to dissuade US buyers. All bodystyles except the Trevi were on offer at one time or another, although some were sold under different names: the Spider was sold as the Lancia Zagato (from 1979) and the Montecarlo as the Lancia Scorpion (because Chevrolet already had rights to the Monte Carlo model name in the US). Federalized cars were originally sold with a 1756 cc twin-cam engine with . This later dropped to as emissions rules were tightened.R&T Buyer's Guide 1979, p. 150 For the 1979 model year, a two-litre engine was installed, with power up somewhat, to . More importantly, torque was up by 17 per cent.R&T Buyer's Guide 1979, pp. 102–103 A black and gold Zagato Limited Edition (LE) of 500 cars was offered for 1979, followed by a Special Edition (SE) of similar livery for 1981. Quality problems meant that US inspectors went to visit the plant to see what could be improved, but Lancia took a hiatus and did not bring any 1980 models. When returning in 1981, the Berlina was dropped as they focussed on the more popular sporting variants. Fuel injection increased the 2.0's power considerably, to about (the published numbers vary considerably). 1982 was the last year for Lancia's half-hearted efforts in the United States.
Model range The Beta was available in a number of different body styles:
Berlina
Introduced in 1972, the first body style to appear, and the most common was the four-door berlina (saloon), with a wheelbase of and 'fastback' styling giving the appearance of a hatchback, although in fact it had a conventional boot like a saloon. This practice was common in the industry at the time as manufacturers deemed that hatchback designs would not be accepted in this market sector. It featured 1400, 1600 and 1800 transversely mounted twin-cam engines based on earlier Fiat designs along with five speed gearbox. In 1974 the 1.8ES version was launched featuring electric windows, alloy wheels and sunroof. At the Turin Auto Show in November 1974 a 1300 engine joined the range at the bottom, then in the fall of 1975 the existing 1600 and 1800 engines were replaced by new 1600 and 2000 units. The 2.0-litre units had improved torque (up 20% to 128 lb ft at 2800 rpm). In the same year Lancia returned to the US market with the Beta. Automatic versions were introduced in 1978. In 1981 the 2.0 became available with electronic fuel injection. Berlina production ended in 1981.
Trevi
Late in the Beta's life, with assistance from Pininfarina, a substantially reworked 4-door three-box, notchback saloon variant was released as the Trevi; the Trevi also introduced an original new dashboard layout designed by Mario Bellini which was then applied to the third series Berlina.
Number built: 194,914 Berlinas plus 36,784 Trevis.
Coupé
In 1973 the second style to appear was a 2+2 two-door coupé with a wheelbase, although due to the fuel crisis did not become available to the public until early 1974. It was launched with 1.6 and 1.8L engines. New 1.6 and 2.0L engines replaced the original units in late 1975, followed by a 1.3L in early 1976. In 1978, the Beta Coupé became available with an automatic transmission and power steering. In 1981, the car received a minor facelift and at the same time the 2.0 became available with fuel Bosch electronic fuel injection. In 1983, a 2.0 VX supercharged engine became available with an output of 135 bhp. The bodywork was developed inhouse by Centro Stile Lancia led by Aldo Castagno, with Piero Castagnero acting as styling consultant. Castagnero had also styled the Beta's predecessor, the Lancia Fulvia saloon and coupé. Number built: 111,801.
This was one of the bodystyles to be marketed in North America. The 2.0L twin-cam I4 offered in North America produced at 5500 rpm.
Spider (Zagato)