The Richter scale. discusses the name at some length. (), also called the Richter magnitude scale, Richter's magnitude scale, and the Gutenberg–Richter scale, is a measure of the strength of earthquakes, developed by Charles Richter in collaboration with Beno Gutenberg, and presented in Richter's landmark 1935 paper, where he called it the "magnitude scale".; . This was later revised and renamed the local magnitude scale, denoted as ML or ML..
Because of various shortcomings of the original ML scale, most seismological authorities now use other similar scales such as the moment magnitude scale (Mw) to report earthquake magnitudes, but much of the news media still erroneously refers to these as "Richter" magnitudes. All magnitude scales retain the logarithmic character of the original and are scaled to have roughly comparable numeric values (typically in the middle of the scale). Due to the variance in earthquakes, it is essential to understand the Richter scale uses common logarithms simply to make the measurements manageable (i.e., a magnitude 3 quake factors 103 while a magnitude 5 quake factors 105 and has seismometer readings 100 times larger).
Richter magnitudes The Richter magnitude of an earthquake is determined from the logarithm of the amplitude of waves recorded by seismographs. Adjustments are included to compensate for the variation in the distance between the various seismographs and the epicenter of the earthquake. The original formula is:
where is the maximum excursion of the Wood-Anderson seismograph, the empirical function depends only on the epicentral distance of the station, . In practice, readings from all observing stations are averaged after adjustment with station-specific corrections to obtain the ML value.
Because of the logarithmic basis of the scale, each whole number increase in magnitude represents a tenfold increase in measured amplitude. In terms of energy, each whole number increase corresponds to an increase of about 31.6 times the amount of energy released, and each increase of 0.2 corresponds to approximately a doubling of the energy released.
Events with magnitudes greater than 4.5 are strong enough to be recorded by a seismograph anywhere in the world, so long as its sensors are not located in the earthquake's shadow.
The following describes the typical effects of earthquakes of various magnitudes near the epicenter. The values are typical and may not be exact in a future event because intensity and ground effects depend not only on the magnitude but also on (1) the distance to the epicenter, (2) the depth of the earthquake's focus beneath the epicenter, (3) the location of the epicenter, and (4) geological conditions.
MagnitudeDescriptionTypical maximum modified Mercalli intensityAverage earthquake effectsAverage frequency of occurrence globally (estimated)1.0–1.9MicroMicroearthquakes, not felt. Recorded by seismographs.This is what Richter wrote in his Elementary Seismology (1958), an opinion copiously reproduced afterward in Earth's science primers. Recent evidence shows that earthquakes with negative magnitudes (down to −0.7) can also be felt in exceptional cases, especially when the focus is very shallow (a few hundred meters). See: Thouvenot, F.; Bouchon, M. (2008). "What is the lowest magnitude threshold at which an earthquake can be felt or heard, or objects thrown into the air?," in Fréchet, J., Meghraoui, M. & Stucchi, M. (eds), Modern Approaches in Solid Earth Sciences (vol. 2), Historical Seismology: Interdisciplinary Studies of Past and Recent Earthquakes, Springer, Dordrecht, 313–326.Continual/several millions per year2.0–2.9MinortoFelt slightly by some people. No damage to buildings.Over one million per year3.0–3.9SlighttoOften felt by people, but very rarely causes damage. Shaking of indoor objects can be noticeable.Over 100,000 per year4.0–4.9LighttoNoticeable shaking of indoor objects and rattling noises. Felt by most people in the affected area. Slightly felt outside. Generally causes zero to minimal damage. Moderate to significant damage is very unlikely. Some objects may fall off shelves or be knocked over.10,000 to 15,000 per year5.0–5.9ModeratetoCan cause damage of varying severity to poorly constructed buildings. Zero to slight damage to all other buildings. Felt by everyone.1,000 to 1,500 per year6.0–6.9StrongtoDamage to a moderate number of well-built structures in populated areas. Earthquake-resistant structures survive with slight to moderate damage. Poorly designed structures receive moderate to severe damage. Felt in wider areas; up to hundreds of kilometers from the epicenter. Strong to violent shaking in the epicentral area.100 to 150 per year7.0–7.9Major or higherCauses damage to most buildings, some to partially or completely collapse or receive severe damage. Well-designed structures are likely to receive damage. Felt across great distances with major damage mostly limited to 250 km from the epicenter. A magnitude 7.0 or greater will result in a tsunami alert being issued to certain regions. 10 to 20 per year8.0–8.9GreatMajor damage to buildings, and structures likely to be destroyed. Will cause moderate to heavy damage to sturdy or earthquake-resistant buildings. Damaging in large areas. Felt in extremely large regions.One per year9.0–9.9ExtremeNear total destruction – severe damage or collapse to all buildings. Heavy damage and shaking extend to distant locations. Permanent changes in ground topography.One to three per century
(Based on U.S. Geological Survey documents.)
The intensity and death toll depend on several factors (earthquake depth, epicenter location, and population density, to name a few) and can vary widely.
Millions of minor earthquakes occur every year worldwide, equating to hundreds every hour every day. On the other hand, earthquakes of magnitude ≥8.0 occur about once a year, on average. The largest recorded earthquake was the Great Chilean earthquake of May 22, 1960, which had a magnitude of 9.5 on the moment magnitude scale.
Seismologist Susan Hough has suggested that a magnitude 10 quake may represent a very approximate upper limit for what the Earth's tectonic zones are capable of, which would be the result of the largest known continuous belt of faults rupturing together (along the Pacific coast of the Americas). A research at the Tohoku University in Japan found that a magnitude 10 earthquake was theoretically possible if a combined of faults from the Japan Trench to the Kuril–Kamchatka Trench ruptured together and moved by (or if a similar large-scale rupture occurred elsewhere). Such an earthquake would cause ground motions for up to an hour, with tsunamis hitting shores while the ground is still shaking, and if this kind of earthquake occurred, it would probably be a 1-in-10,000-year event.
Development
Prior to the development of the magnitude scale, the only measure of an earthquake's strength or "size" was a subjective assessment of the intensity of shaking observed near the epicenter of the earthquake, categorized by various seismic intensity scales such as the Rossi–Forel scale. ("Size" is used in the sense of the quantity of energy released, not the size of the area affected by shaking, though higher-energy earthquakes do tend to affect a wider area, depending on the local geology.) In 1883, John Milne surmised that the shaking of large earthquakes might generate waves detectable around the globe, and in 1899 E. Von Rehbur Paschvitz observed in Germany seismic waves attributable to an earthquake in Tokyo.. In the 1920s, Harry O. Wood and John A. Anderson developed the Wood–Anderson seismograph, one of the first practical instruments for recording seismic waves.; Wood then built, under the auspices of the California Institute of Technology and the Carnegie Institute, a network of seismographs stretching across Southern California.. He also recruited the young and unknown Charles Richter to measure the seismograms and locate the earthquakes generating the seismic waves..
In 1931, Kiyoo Wadati showed how he had measured, for several strong earthquakes in Japan, the amplitude of the shaking observed at various distances from the epicenter. He then plotted the logarithm of the amplitude against the distance and found a series of curves that showed a rough correlation with the estimated magnitudes of the earthquakes.. Richter resolved some difficulties with this method. and then, using data collected by his colleague Beno Gutenberg, he produced similar curves, confirming that they could be used to compare the relative magnitudes of different earthquakes..
Additional developments were required to produce a practical method of assigning an absolute measure of magnitude. First, to span the wide range of possible values, Richter adopted Gutenberg's suggestion of a logarithmic scale, where each step represents a tenfold increase of magnitude, similar to the magnitude scale used by astronomers for star brightness. Second, he wanted a magnitude of zero to be around the limit of human perceptibility.: . Third, he specified the Wood–Anderson seismograph as the standard instrument for producing seismograms. Magnitude was then defined as "the logarithm of the maximum trace amplitude, expressed in microns", measured at a distance of . The scale was calibrated by defining a magnitude 0 shock as one that produces (at a distance of ) a maximum amplitude of 1 micron (1 μm, or 0.001 millimeters) on a seismogram recorded by a Wood-Anderson torsion seismometer.. See also ; . Finally, Richter calculated a table of distance corrections,, Table I. in that for distances less than 200 kilometers. the attenuation is strongly affected by the structure and properties of the regional geology..
When Richter presented the resulting scale in 1935, he called it (at the suggestion of Harry Wood) simply a "magnitude" scale.. His article is titled: "An Instrumental Earthquake Magnitude Scale". "Richter magnitude" appears to have originated when Perry Byerly told the press that the scale was Richter's and "should be referred to as such.". In 1956, Gutenberg and Richter, while still referring to "magnitude scale", labelled it "local magnitude", with the symbol ML, to distinguish it from two other scales they had developed, the surface-wave magnitude (MS) and body wave magnitude (MB) scales.
Details
The Richter scale was defined in 1935 for particular circumstances and instruments; the particular circumstances refer to it being defined for Southern California and "implicitly incorporates the attenuative properties of Southern California crust and mantle." The particular instrument used would become saturated by strong earthquakes and unable to record high values. The scale was replaced in the 1970s by the moment magnitude scale (MMS, symbol Mw); for earthquakes adequately measured by the Richter scale, numerical values are approximately the same. Although values measured for earthquakes now are Mw, they are frequently reported by the press as Richter values, even for earthquakes of magnitude over 8, when the Richter scale becomes meaningless.
The Richter and MMS scales measure the energy released by an earthquake; another scale, the Mercalli intensity scale, classifies earthquakes by their effects, from detectable by instruments but not noticeable, to catastrophic. The energy and effects are not necessarily strongly correlated; a shallow earthquake in a populated area with soil of certain types can be far more intense in impact than a much more energetic deep earthquake in an isolated area.
Several scales have been historically described as the "Richter scale", especially the local magnitude ML and the surface wave Ms scale. In addition, the body wave magnitude, Mb, and the moment magnitude, Mw, abbreviated MMS, have been widely used for decades. A couple of new techniques to measure magnitude are in the development stage by seismologists.