Sand is a granular material composed of finely divided mineral particles. Sand has various compositions but is usually defined by its grain size. Sand grains are smaller than gravel and coarser than silt. Sand can also refer to a textural class of soil or soil type; i.e., a soil containing more than 85 percent sand-sized particles by mass.
The composition of sand varies, depending on the local rock sources and conditions, but the most common constituent of sand in inland continental settings and non-tropical coastal settings is silica (silicon dioxide, or SiO2), usually in the form of quartz.
Calcium carbonate is the second most common type of sand. One such example of this is aragonite, which has been created over the past 500million years by various forms of life, such as coral and shellfish. It is the primary form of sand apparent in areas where reefs have dominated the ecosystem for millions of years, as in the Caribbean. Somewhat more rarely, sand may be composed of calcium sulfate, such as gypsum and selenite, as is found in places such as White Sands National Park and Salt Plains National Wildlife Refuge in the U.S.
Sand is a non-renewable resource over human timescales, and sand suitable for making concrete is in high demand. Desert sand, although plentiful, is not suitable for concrete. Fifty billion tons of beach sand and fossil sand are used each year for construction.
Composition
The exact definition of sand varies. The scientific Unified Soil Classification System used in engineering and geology corresponds to US Standard Sieves, and defines sand as particles with a diameter of between 0.074 and 4.75 millimeters.Unified Soil Classification System By another definition, in terms of particle size as used by geologists, sand particles range in diameter from 0.0625 mm (or mm) a volume of approximately 0.00012 cubic millimetres, to 2 mm, a volume of approximately 4.2 cubic millimetres, the difference in volumes being 34,688 measures difference. Any particle falling within this range of sizes is termed a sand grain. Sand grains are between gravel (with particles ranging from 2 mm up to 64 mm by the latter system, and from 4.75 mm up to 75 mm in the former) and silt (particles smaller than 0.0625 mm down to 0.004 mm). The size specification between sand and gravel has remained constant for more than a century, but particle diameters as small as 0.02 mm were considered sand under the Albert Atterberg standard in use during the early 20th century. The grains of sand in Archimedes' The Sand Reckoner written around 240 BCE, were 0.02 mm in diameter. A 1938 specification of the United States Department of Agriculture was 0.05 mm.Urquhart, Leonard Church, "Civil Engineering Handbook" McGraw-Hill Book Company (1959) p. 8-2 A 1953 engineering standard published by the American Association of State Highway and Transportation Officials set the minimum sand size at 0.074 mm. Sand feels gritty when rubbed between the fingers. Silt, by comparison, feels like flour.
ISO 14688 grades sands as fine, medium, and coarse with ranges 0.063 mm to 0.2 mm to 0.63 mm to 2.0 mm. In the United States, sand is commonly divided into five sub-categories based on size: very fine sand ( – mm diameter), fine sand ( mm – mm), medium sand ( mm – mm), coarse sand ( mm – 1 mm), and very coarse sand (1 mm – 2 mm). These sizes are based on the Krumbein phi scale, where size is Φ = -log2D; D being the particle size in mm. On this scale, for sand the value of Φ varies from −1 to +4, with the divisions between sub-categories at whole numbers.
The most common constituent of sand, in inland continental settings and non-tropical coastal settings, is silica (silicon dioxide, or SiO2), usually in the form of quartz, which, because of its chemical inertness and considerable hardness, is the most common mineral resistant to weathering.
The composition of mineral sand is highly variable, depending on the local rock sources and conditions. The bright white sands found in tropical and subtropical coastal settings are eroded limestone and may contain coral and shell fragments in addition to other organic or organically derived fragmental material, suggesting that sand formation depends on living organisms, too.Seaweed also plays a role in the formation of sand . Susanscott.net (1 March 2002). Retrieved on 24 November 2011. The gypsum sand dunes of the White Sands National Park in New Mexico are famous for their bright, white color. Arkose is a sand or sandstone with considerable feldspar content, derived from weathering and erosion of a (usually nearby) granitic rock outcrop. Some sands contain magnetite, chlorite, glauconite, or gypsum. Sands rich in magnetite are dark to black in color, as are sands derived from volcanic basalts and obsidian. Chlorite-glauconite bearing sands are typically green in color, as are sands derived from basaltic lava with a high olivine content. Many sands, especially those found extensively in Southern Europe, have iron impurities within the quartz crystals of the sand, giving a deep yellow color. Sand deposits in some areas contain garnets and other resistant minerals, including some small gemstones.
Sources Rocks erode or weather over a long period of time, mainly by water and wind, and their sediments are transported downstream. These sediments continue to break apart into smaller pieces until they become fine grains of sand. The type of rock the sediment originated from and the intensity of the environment give different compositions of sand. The most common rock to form sand is granite, where the feldspar minerals dissolve faster than the quartz, causing the rock to break apart into small pieces. In high energy environments rocks break apart much faster than in more calm settings. In granite rocks this results in more feldspar minerals in the sand because they do not have as much time to dissolve away. The term for sand formed by weathering is "epiclastic".
Sand from rivers are collected either from the river itself or its flood plain and accounts for the majority of the sand used in the construction industry. Because of this, many small rivers have been depleted, causing environmental concern and economic losses to adjacent land. The rate of sand mining in such areas greatly outweighs the rate the sand can replenish, making it a non-renewable resource.
Sand dunes are a consequence of dry conditions or wind deposition. The Sahara Desert is very dry because of its geographic location and proximity to the equator. It is known for its vast sand dunes, which exist mainly due to a lack of vegetation and water. Over time, wind blows away fine particles, such as clay and dead organic matter, leaving only sand and larger rocks. Only 15% of the Sahara is sand dunes, while 70% is bare rock. The wind is responsible for creating these different environments and shaping the sand to be round and smooth. These properties make desert sand unusable for construction.
Beach sand is also formed by erosion. Over thousands of years, rocks are eroded near the shoreline from the constant motion of waves and the sediments build up. Weathering and river deposition also accelerate the process of creating a beach, along with marine animals interacting with rocks, such as eating the algae off of them. Once there is a sufficient amount of sand, the beach acts as a barrier to keep the land from eroding any further. This sand is ideal for construction as it is angular and of various sizes.
Marine sand (or ocean sand) comes from sediments transported into the ocean and the erosion of ocean rocks. The thickness of the sand layer varies, however it is common to have more sand closer to land; this type of sand is ideal for construction and is a very valuable commodity. Europe is the main miners of marine sand, which greatly hurts ecosystems and local fisheries.
Study
The study of individual grains can reveal much historical information as to the origin and kind of transport of the grain.Krinsley, D.H., Smalley, I.J. 1972. Sand. American Scientist 60, 286–291 Quartz sand that is recently weathered from granite or gneiss quartz crystals will be angular. It is called grus in geology or sharp sand in the building trade where it is preferred for concrete, and in gardening where it is used as a soil amendment to loosen clay soils. Sand that is transported long distances by water or wind will be rounded, with characteristic abrasion patterns on the grain surface. Desert sand is typically rounded.
People who collect sand as a hobby are known as arenophiles. Organisms that thrive in sandy environments are psammophiles.
Uses
Abrasion: Before sandpaper, wet sand was used as an abrasive element between rotating devices with elastic surface and hard materials such as very hard stone (making of stone vases), or metal (removal of old stain before re-staining copper cooking pots). Agriculture: Sandy soils are ideal for crops such as watermelons, peaches, and peanuts, and their excellent drainage characteristics make them suitable for intensive dairy farming. Air filtration: Finer sand particles mixed with cloth was commonly used in certain gas mask filter designs but have largely been replaced by microfibers. Aquaria: Sand makes a low-cost aquarium base material which some believe is better than gravel for home use. It is also a necessity for saltwater reef tanks, which emulate environments composed largely of aragonite sand broken down from coral and shellfish. Artificial reefs: Geotextile bagged sand can serve as the foundation for new reefs. Artificial islands in the Persian Gulf. Beach nourishment: Governments move sand to beaches where tides, storms, or deliberate changes to the shoreline erode the original sand. Brick: Manufacturing plants add sand to a mixture of clay and other materials for manufacturing bricks. Cob: Cob is a building material consisting of water, organic material (like straw), lime, and subsoil, which largely consists of sand. Coarse sand makes up as much as 75% of cob. Concrete: Sand is often a principal component of this critical construction material. Glass: Sand rich in silica is the principal component in common glasses. Hydraulic fracturing: A drilling technique for natural gas, which uses rounded silica sand as a "proppant", a material to hold open cracks that are caused by the hydraulic fracturing process. Landscaping: Sand makes small hills and slopes (golf courses would be an example). Mortar: Sand is mixed with masonry cement or Portland cement and lime to be used in masonry construction. Paint: Mixing sand with paint produces a textured finish for walls and ceilings or non-slip floor surfaces. Railroads: Engine drivers and rail transit operators use sand to improve the traction of wheels on the rails. Recreation: Playing with sand is a favorite beach activity. One of the most beloved uses of sand is to make sometimes intricate, sometimes simple structures known as sand castles, proverbially impermanent. Special play areas for children, enclosing a significant area of sand and known as sandboxes, are common on many public playgrounds, and even at some single-family homes. Sand dunes are also popular among climbers, motorcyclists and beach buggy drivers. Roads: Sand improves traction (and thus traffic safety) in icy or snowy conditions. Sand animation: Performance artists draw images in sand. Makers of animated films use the same term to describe their use of sand on frontlit or backlit glass. Sand casting: Casters moisten or oil molding sand, also known as foundry sand and then shape it into molds into which they pour molten material. This type of sand must be able to withstand high temperatures and pressure, allow gases to escape, have a uniform, small grain size, and be non-reactive with metals.