The QF 4.7-inch gun Mks I, II, III, and IVMk I = Mark 1, Mk II = Mark 2, Mk III = Mark 3, Mk IV = Mark 4. Britain used Roman numerals to denote marks (models) of ordnance until after the Second World War. Hence, these were the first four models of British QF 4.7-inch gun. were a family of British quick-firing naval and coast defence guns of the late 1880s and 1890s that served with the navies of various countries. They were also mounted on various wheeled carriages to provide the British Army with a long-range gun. They all had a barrel of 40 calibres length.
The gun was originally designed to replace the older BL 5-inch (127 mm) naval guns. It was optimised for the modern smokeless propellants, such as cordite, and could be loaded and fired far more rapidly than the BL 5-inch gun while firing a shell only slightly lighter.
Design and development The guns were designed and manufactured by the Elswick Ordnance Company, part of Armstrong Whitworth. They were developed to exploit the new "QF" technology, which involved loading the propellant charge in a brass case with integrated primer in its base. This allowed a faster rate of fire than the older "Breech Loading" system, where the propellant was loaded in cloth bags and then a separate friction or percussion tube fitted into the breech for firing. The brass case sealed the breech, allowing a lighter mechanism, and at the same time disposed with the necessity of washing or sponging any smouldering fragments left from the previous shot, which could ignite the charge (then of black powder) prematurely. The QF principle had proved successful with the much smaller QF 3 pounder Hotchkiss and Nordenfelt QF 3 and 6-pounders from 1885 onwards.
The first QF gun of this class was designated Pattern "M" in Elswick and was submitted to the Admiralty in 1886. Initially designed for a projectile which was lengthened to after exhaustive experimentation, it was actually adopted not by the UK but by Italy as M1889 (see below).
They soon became a major export item and hence were actually of 4.724 inches (120mm) calibre to meet the requirements of metricised navies: 4.7 inch is an approximation used for the British designation. The guns, Mark I to Mark III, were Pattern P, Pattern Q and Pattern T respectively according to Elswick nomenclature. All three differed in detail of construction but were of the tube and hoop types. The Mark IV differed from these by incorporating a wire wound element to its construction. As first built, all used a three-motion screw breech, some were altered later by modifying the three-motion screw becoming "A" subtypes, or by fitting a single motion breech ("B" type). Army guns altered to use a bagged charge with a 3-inch steel (instead of the more usual brass) breech-sealing case were renumbered as Mark VI.
United Kingdom service Royal Navy service British pre-dreadnoughts and cruisers of the period used these guns. Total production was 154 Mark I, 91 Mark II, 338 Mark III and 584 Mark IV. The Royal Navy received 776 of these guns directly. The Army transferred a further 110 to the Navy.
The gave up their guns to produce high-angle anti-aircraft guns to defend London.
By the First World War, the guns were obsolete for warship use, but many were re-mounted on merchant ships and troopships for defence against enemy submarines and commerce raiders.
British Army service In land service, limited numbers were mounted for use as fixed coast artillery. In addition, some Mark IV guns were mounted on converted 40-Pr Rifled Breech Loading Gun carriages for use by batteries of the Royal Garrison Artillery (Volunteers) from the early 1900s. The 1st Ayrshire and Galloway Royal Garrison Artillery (Volunteers) received a number of these guns in 1903 to provide armament for their three heavy batteries.Lt Gen Sir James Moncrieff Grierson, Records of the Scottish Volunteer Force 1859–1908, William Blackwood & Sons Ltd, 1909, p146 These batteries were semi-mobile and equipped with limbers, which could be drawn by horses or gun tractors. They continued in use with artillery units of the Territorial Force, with some being used into the First World War.
Second Boer War (1899–1902)
British forces in the Second Boer War were initially outgunned by the long range Boer artillery. Captain Percy Scott of HMS Terrible first improvised timber static siege mountings for two guns from the Cape Town coastal defences, to counter the Boers' "Long Tom" gun during the Siege of Ladysmith in 1899–1900.Hall 1971. Captain Scott then improvised a travelling carriage for 4.7-inch guns removed from their usual static coastal or ship mountings to provide the army with a heavy field gun. These improvised carriages lacked recoil buffers and hence in action drag shoes and attachment of the carriage by cable to a strong point in front of the gun were necessary to control the recoil. They were manned by Royal Navy crews and required up to 32 oxen to move.
First World War South-West Africa Campaign (1914–1915)
The same guns mounted on "Percy Scott" carriages were used by South African forces against German forces in the South-West Africa campaign in the First World War. Guns were landed at Lüderitz Bay in October 1914 and later at Walvis Bay in February 1915 and moved inland across the desert in support of South African troops.
Western Front (1914–1917)
Up to 92 QF 4.7-inch guns on more modern Mk I "Woolwich" carriages dating from June 1900 with partially effective (12-inch) recoil buffers, and on heavier "converted" carriages from old RML 40 pounder guns, went to France with Royal Garrison Artillery units, mostly of the Territorial Force, in 1914–1917.
They figured prominently in the early battles, such as at Neuve Chapelle in March 1915 where there were 32, and only 12 60-pounders, assigned to counter-battery fire. General Farndale reports that counter-battery fire there failed to deal with the German artillery, but ascribes the failure to the as yet imprecise nature of long range map shooting, and the difficulty of maintaining forward observers on the flat terrain.Farndale 1986, pages 87, 88.
By the Battle of Aubers Ridge on 9 May 1915, the barrels of the 28 guns of the 3rd and 8th Heavy Brigades and the 1st West Riding and 1st Highland Heavy Batteries engaged were now so worn that driving bands were stripped off shells at the muzzle, limiting accuracy.Farndale 1986, page 104. In addition, two guns in the armoured train "Churchill" were in action at Aubers Ridge. Thirty-three 60-pounders were available. Counter-battery fire again failed due to the inaccuracy of the worn-out guns and also because the army still lacked accurate means of locating enemy guns,Farndale 1986, pages 106, 107. as air observation and reporting and use of radio was only beginning.
The inaccuracy through wear and the relatively light shell diminished their usefulness in the developing trench warfare, and they were replaced by the modern 60-pounder guns as they became available. At the Battle of the Somme in June–July 1916, there were 32 4.7-inch guns and 128 60-pounders engaged.Farndale 1986, page 144. However, the last were not withdrawn until April 1917. Guns withdrawn from the Western Front were redeployed to other fronts, such as Italy and Serbia.Hogg & Thurston 1972, page 110.
Battle of Gallipoli (1915)
A 4.7-inch gun was used by the 1st Heavy Artillery Battery, a joint unit of Australians and Royal Marines, on Gallipoli to counter long range Turkish fire from the "Olive Grove" (in fact "Palamut Luk" or Oak Grove)Mallett 1999. between Gaba Tepe and Maidos. Lt-Colonel Rosenthal, commanding 3rd Australian Field Artillery Brigade, noted: "I had made continual urgent representations for two 4.7-inch guns for right flank to deal with innumerable targets beyond the range of 18-prs., but it was not till 11 July that one very old and much worn gun arrived, and was placed in position on right flank, firing its first round on 26 July."Rosenthal 1920. This gun was destroyed and left behind at the withdrawal from Gallipoli but later salvaged as a museum piece.Mallett 2005. The burst barrel is on display at the Australian War Memorial.
Salonika front Several guns mounted on "Percy Scott" carriages served with British and Serb forces in the Salonika (Macedonian) campaign from January 1916 onwards.
Italian service In Italian service, QF 4.7-inch guns were known as 120/40 A 1889 and 120/40 A 1891. Italian guns produced under license by Ansaldo were similar in construction to the British Mk I*. They armed auxiliary cruisers, dreadnought battleships, ironclads, predreadnought battleships, protected cruisers and torpedo cruisers of the Regia Marina. They saw action aboard ships in the Italo-Turkish War, World War I, Second Italo-Ethiopian War and World War II.
Japanese service First Sino-Japanese War Japanese belted cruiser Chiyoda launched in 1890 was armed with ten QF 4.7-inch Guns in single mounts, mounted one each in the bow and stern, and four on each side in sponsons. This was one of the first naval use of this gun. After Chiyoda, the Imperial Japanese Navy aggressively introduced quick-firing guns in their cruisers. Six Japanese cruisers that fought Battle of the Yalu River in 1894 had a total of 60 QF 4.7-inch guns. Along with eight QF 6-inch guns, overwhelming superiority in quick-firing guns of the Japanese Fleet gave it tactical advantage over the Chinese Beiyang Fleet and was one of the decisive factors of the Naval Battle.
Licensed products The Japanese Type 41 4.7-inch/40 (12 cm) naval gun was a license-produced copy of the Elswick Mark IV. Initially, a number were procured directly from Elswick in England. After the turn of the century, production in Japan was under the designation "Mark IVJ". The gun was re-designated as Type 41 on 25 December 1908, after the 41st year in the reign of Japanese Emperor Meiji. It was further re-designated in centimeters on 5 October 1917 as part of the standardization process for the Imperial Japanese Navy to the metric system. Although finally classified as a "12 cm" gun the bore was unchanged at 4.724 inches.
During the First World War, the Japanese Navy transferred 24 original Elswick-built and 13 Mark IVJ to Britain as part of their military assistance to the Allies under the Anglo-Japanese Alliance. In 1940, some of these weapons were emplaced in British coastal defence batteries; for instance, at Mersea Island in Essex.http://unlockingessex.essexcc.gov.uk/custom_pages/monument_detail.asp?kids=1&monument_id=31487
It was the standard secondary or tertiary armament on most Japanese cruisers built between 1900 and 1920, and was the primary armament on a number of destroyers, including the . Some units were still in service as late as the Pacific War.
United States service
In 1898, the United States Army acquired 35 British QF 4.7-inch guns; these were designated "4.72-inch Armstrong guns". Eighteen were 40 caliber Mark IV weapons, thirteen were 45 caliber, and four were 50 caliber; apparently the 45 and 50 caliber guns were non-standard export models.Gun and Carriage cards, National Archives and Records Administration, Record Group 156, Records of the Chief of Ordnance, Entry 712 These and the nine 6-inch Armstrong guns acquired at the same time appear to have been purchased to rapidly arm coast defense batteries with modern quick-firing medium-caliber weapons due to the outbreak of the Spanish–American War. It was feared that the Spanish fleet might bombard US East Coast ports. The massive Endicott program of coast defenses was still years from completion, and most existing defenses dated from the 1870s with muzzle-loading weapons. By the end of 1899, 34 of the 4.7-inch guns had been deployed at 17 forts on the East and Gulf Coasts; the remaining gun (40 caliber) was retained for testing at the Sandy Hook Proving Ground at Fort Hancock, New Jersey.Berhow, pp. 86–87, 200–226