Straw-bale construction is a building method that uses bales of straw (usually wheatAsdrubali, F., D’Alessandro, F., Schiavoni, S.: A review of unconventional sustainable building insulation materials. Sustain Mater Technol. 4, 1–17 (2015). https://doi.org/10.1016/j.susmat.2015.05.002 straw) as structural elements, building insulation, or both. This construction method is commonly used in natural building or "brown" construction projects. Research has shown that straw-bale construction is a sustainable method for building, from the standpoint of both materials and energy needed for heating and cooling.Milutiene, Edita, et al. "increase in Buildings Sustainability Using Renewable materials and Energy." Clean Technologies & Environmental policy 14.6 (2012): 1075-84.Print.
Advantages of straw-bale construction over conventional building systems include the renewable nature of straw, cost, easy availability, natural fire-retardant and high insulation value.Canada Mortgage and Housing Corporation. "Energy Use In Straw Bale Houses" . Retrieved on 4 September 2008. Disadvantages include susceptibility to rot, difficulty in obtaining insurance coverage, and high space requirements for the straw itself. Research has been done using moisture probes placed within the straw wall in which 7 of 8 locations had moisture contents of less than 20%. This is a moisture level that does not aid in the breakdown of the straw.Goodhew, Steve, Richard Griffiths, and Tom Woolley. "An Investigation of the Moisture Content in the Walls of a Straw-Bale Building." Building and Environment39.12 (2004): 1443-51. Print. However, proper construction of the straw-bale wall is important in keeping moisture levels down, just as in the construction of any type of building.
History Straw houses have been built on the African plains since the Paleolithic Era. Straw was used in construction 400 years ago in Germany; and straw-thatched roofs have long been used in northern Europe and Asia. When European Settlers came to North America, teepees were insulated in winter with loose straw between the inner lining and outer cover.Marks, Leanne R. (2005). "Straw Bale as a Viable, Cost Effective, and Sustainable Building Material for use in Southeast Ohio". Master's thesis, Ohio University. Retrieved 2010-08-10.
Straw-bale construction was greatly facilitated by the mechanical hay baler, which was invented in the 1850s and was widespread by the 1890s. It proved particularly useful in the Nebraska Sandhills. Pioneers seeking land under the 1862 Homestead Act and the 1904 Kinkaid Act found a dearth of trees over much of Nebraska. In many parts of the state, the soil was suitable for dugouts and sod houses. Retrieved 2010-08-29. However, in the Sandhills, the soil generally made poor construction sod;Spencer, Janet Jeffries and D. Murphy (1979). Retrieved 2010-08-10. in the few places where suitable sod could be found, it was more valuable for agriculture than as a building material.Hammett, Jerilou and Kingsley (1998). "The Strawbale Search". DESIGNER/builder magazine, August 1998. Article reproduced at "The Last Straw" website. Retrieved 2010-08-10.
The first documented use of hay bales in construction in Nebraska was a schoolhouse built in 1896 or 1897. Unfenced and unprotected by stucco or plaster, it was reported in 1902 as having been eaten by cows. To combat this, builders began plastering their bale structures; if cement or lime stucco was unavailable, locally obtained "gumbo mud" was employed. Between 1896 and 1945, an estimated 70 straw-bale buildings, including houses, farm buildings, churches, schools, offices, and grocery stores had been built in the Sandhills. In 1990, nine surviving bale buildings were reported in Arthur and Logan Counties,Kay, John, David Anthone, Robert Kay, and Christina Hugly (1990). Retrieved 2010-08-29. including the 1928 Pilgrim Holiness Church in the village of Arthur, which is listed in the National Register of Historic Places.
Since the 1990s straw-bale construction has been substantially revived, particularly in North America, Europe, and Australia. Straw was one of the first materials to be used in green buildings. This revival is likely attributed to greater environmental awareness and the material's natural, non-toxic qualities, low embodied energy, and relative affordability. Straw-bale construction has encountered issues regarding building codes depending on the location of the building.Kathryn Henderson Science, Technology, & Human Values, Vol. 31, No. 3, Ethics and Engineering Design (May, 2006), pp. 261-288 However, in the USA, the introduction of Appendices S and R in the 2015 International Residential Code has helped to legitimize and improve understanding of straw-bale construction. In France, the approval in 2012 of professional rules for straw-building recognized it as “common technology” and qualifies for standard-insurance programs.
Method
Straw bale building typically consists of stacking rows of bales (often in running-bond) on a raised footing or foundation, with a moisture barrier or capillary break between the bales and their supporting platform. There are two types of straw-bales commonly used, those bound together with two strings and those with three. The three string bale is the larger in all three dimensions. Bale walls can be tied together with pins of bamboo or wood (internal to the bales or on their faces), or with surface wire meshes, and then stuccoed or plastered, either with a lime-based formulation or earth/clay render. The bales may actually provide the structural support for the building ("load-bearing" or "Nebraska-style" technique), as was the case in the original examples from the late 19th century. The plastered bale assembly also can be designed to provide lateral and shear support for wind and seismic loads.
Alternatively, bale buildings can have a structural frame of other materials, usually lumber or timber-frame, with bales simply serving as insulation and plaster substrate, ("infill" or "non-loadbearing" technique), which is most often required in northern regions and/or in wet climates. In northern regions, the potential snow-loading can exceed the strength of the bale walls. In wet climates, the imperative for applying a vapor-permeable finish precludes the use of cement-based stucco. Additionally, the inclusion of a skeletal framework of wood or metal allows the erection of a roof prior to raising the bales, which can protect the bale wall during construction, when it is the most vulnerable to water damage in all but the most dependably arid climates. A combination of framing and load-bearing techniques may also be employed, referred to as "hybrid" straw bale construction.
Straw bales can also be used as part of a spar and membrane structure (SMS) wall system in which lightly reinforced sprayed concrete skins are interconnected with extended X-shaped light rebar in the head joints of the bales.Black, Gary, and Mannik, Henri, "Spar and Membrane Structure" The Last Straw journal, #17, Winter 1997 In this wall system the concrete skins provide structure, seismic reinforcing, and fireproofing, while the bales are used as leave-in formwork and insulation.
The University of Bath has completed a research programme which used ‘ModCell’ panels—prefabricated panels consisting of a wooden structural frame infilled with straw bales and rendered with a breathable lime-based system—to build 'BaleHaus', a straw bale construction on the university's campus. Monitoring work of the structure carried out by architectural researchers at the university has found that as well as reducing the environmental footprint, the construction offers other benefits, including healthier living through higher levels of thermal insulation and regulation of humidity levels. The group has published a number of research papers on its findings.
High density pre-compressed bales (straw blocks) can bear higher loads than traditional field bales (bales created with baling machines on farms). While field bales support around of wall length, high-density bales can bear at least .
Bale buildings can also be constructed of non-straw bales—such as those made from recycled material such as tires, cardboard, paper, plastic, and carpeting—and even bags containing "bales" of wood chips or rice hulls.
Straw bales have also been used in very energy efficient high-performance buildings such as the S-House in Austria which meets the Passivhaus energy standard. In South Africa, a five-star lodge made from 10,000 strawbales has housed world leaders Nelson Mandela and Tony Blair. In the Swiss Alps, in the little village of Nax Mont-Noble, construction works have begun in October 2011 for the first hotel in Europe built entirely with straw bales. The Harrison Vault, in Joshua Tree, California, is engineered to withstand the high seismic loads in that area using only the assembly consisting of bales, lath and plaster. The technique was used successfully for strawbale housing in rural China. Straw bale domes along the Syrio-African rift at Kibbutz Lotan have an interior geodesic frame of steel pipes. Another method to reap the benefits of straw is to incorporate straw-bale walls into a pre-existing structure.Whitty, Cadmon. "I Wrapped My House in Straw: A Straw Bale Builder Turns an Ugly old, Energy-Eating House into a Cozy, Efficient Home with a Unique Straw Bale Retrofit Process." Natural Life Sept.-Oct. 2009 Print.
Straw bales are widely used to insulate walls, but they may also be used to insulate roofs and sub-floors.Cascone, S., Catania, F., Gagliano, A., Sciuto, G., et al.: Energy performance and environmental and economic assessment of the platform frame system with compressed straw. Energy Build 166, 83–92 (2018). https://doi.org/10.1016/j.enbuild.2018.01.035
Thermal properties
Compressed straw bales have a wide range of documented R-value. R-value is a measurement of a materials insulating quality, higher the number the more insulating. The reported R-value ranges from 17–55 (in American units) or 3–9.6 (in SI) depending on the study, differing wall designs could be responsible for wide range in R-value. given that the bales are over a foot thick, the R-value per inch is lower than most other commercial insulation types including batts (3–4) and foamboard (~5). Bale walls are typically coated with a thick layer of plaster, which provides a well-distributed thermal mass, active on a short-term (diurnal) cycle. The combination of insulation and mass provide an excellent platform for passive solar building design for winter and summer.
In common with most building materials, there is a degree of uncertainty in the thermal conductivity due to the influences of temperature, moisture content and density. However, from evaluation of a range of literature and experimental data, a value of 0.064 W/m·K is regarded as a representative design value for straw bales at the densities typically used in building construction.
Compressed and plastered straw bale walls are also resistant to fire.